[. . . ] Short press: Switch on car sound system In operation: Mute car sound system (Mute) Long press: Switch off car sound system Button (only Toronto 410 BT) Ending/rejecting a phone call button (only Toronto 410 BT) Short press: Answering a call, speed dial Long press: Open the phone book of the cell phone or activate voice dialing The car sound system was manufactured according to the state of the art and established safety guidelines. Even so, dangers may occur if you do not observe the safety notes in these instructions. These instructions contain important information to easily and safely install and operate the car sound system. Read these instructions carefully and completely before using the car sound system. [. . . ] In the reception areas "USA" and "SOUTH AMERICA", you can also store 5 AM stations in the AMT memory bank. The tuner starts the automatic station seek tuning; the display shows "FM TSTORE" or "AM TSTORE". After the storing is completed, the radio plays the station at memory location 1 of the FMT or AMT level. As soon as a station with the desired programme type is found, it remains being tuned into. notes: · If no station with the selected programme type is found, "PTY NONE" is briefly displayed and 5 beeps can be heard. If the tuned radio station or another station on the broadcasting network broadcasts your selected programme type at a later point in time, the car sound system will automatically switch from the currently tuned station or from the current audio source (e. If a CD is ejected and not removed, the drive will automatically draw it back in again after approx. The respective audio source can be selected only if a corresponding CD is inserted or a corresponding device is connected. If the car sound system first has to read the data of a connected device or data carrier before the playback, the display shows "READING". You can also eject CDs while the car sound system is switched off or whilst another audio source is activated. U Pull the protective cap of the USB socket 9 to the front until it moves out of the socket and fold it to the right. If the connected USB data carrier cannot be seen, "USB ERROR" is briefly displayed. The time required for reading in the data depends on the design and size of the USB data carrier. If the inserted SD card cannot be played, "SD ERROR" is briefly displayed. The time required for reading in the data depends on the design and size of the SD card. Note: If the current track plays longer than 3 seconds, pressing 7 once restarts the track. Note: In iPod mode, this allows you to change to the previous/next folder of the current category, e. To the next genre, if you previously selected a track on the iPod via the corresponding genre. U Insert the SD/MMC card with its labelled side up and its contacts first into the card slot @ until it clicks into place. After switch-on, the device automatically selects the inserted SD card as audio source. U Press and hold down the button / 7 until the desired position has been reached. 2 seconds to start the scan, or briefly to continue playing the currently scanned track. [. . . ] - or u Briefly press the MENU button 2 to confirm the name entered and to exit the user menu. The name entered is shown on the display as soon as you select the AUX source. FAST BROWSE Switching fast track selection in browse mode on or off using the volume control 4 and the On/Off button 3. U Press the / button 7 to toggle between the display of the version number of CPU (P) and software (E). [. . . ]